Tesla License Plate Screws Installation Guide
Your kit includes one of the following screw lengths:
-
6 mm: License plate only (no frame)
-
8 mm: License plate with a thin frame
-
10 mm: License plate with a thick frame (such as silicone)
Installation
- Remove the factory rear license plate screws.
- Position your license plate and frame (if applicable).
- Hand-thread each OttoSpeed screw to avoid cross-threading.
- Tighten securely using the included security tool. Do not overtighten.
- Store the security tool in a safe place for future use.
Compatibility: OttoSpeed Tesla anti-theft screws are designed for factory rear license plate mounting points. Tesla front license plate brackets are typically aftermarket or dealer-installed and often require different screws.
